Gelişmiş Arama

Basit öğe kaydını göster

dc.contributor.authorYılmaz, Çağatay
dc.contributor.authorALI, Hafiz Qasim
dc.contributor.authorYıldız, Mehmet
dc.date.accessioned2022-08-23T06:50:45Z
dc.date.available2022-08-23T06:50:45Z
dc.date.issued2022en_US
dc.identifier.urihttps://doi.org/10.35414/akufemubid.1018774
dc.identifier.urihttps://hdl.handle.net/20.500.12573/1359
dc.description.abstractIn this study, five differently oriented sets of 3D-printed tensile samples are produced using the Fused Deposition Method (FDM). Among these five sets, three are used to determine the elastic constant to be used in Classical Lamination Theory (CLT), which is generally used to model fiber-reinforced polymers (FRP). Based on the obtained results, CLT is further applied to the remaining two sets of unreinforced 3D-printed polymer samples where the deposition direction varies in each layer. The stress and strain calculated with CLT are then compared with experimental results obtained through tensile testing. The comparison depicts that experimental and CLT results are in good agreement at lower strain levels. In contrast, the stress calculated with CLT deviates from the experimental result at the higher strain levels.Thereafter, a full-field surface strain mapping is applied by using Digital Image Correlation (DIC) Techniques to reveal the damage progression and failure of Fused Deposition Method 3-D Printed Plastics.en_US
dc.language.isoengen_US
dc.publisherAfyon Kocatepe Üniversitesien_US
dc.relation.isversionof10.35414/akufemubid.1018774en_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subject3D Plastic Printeren_US
dc.subjectFused Deposition Methoden_US
dc.subjectClassical Lamination Theoryen_US
dc.subjectPolymeren_US
dc.subjectTensile Testen_US
dc.subjectDICen_US
dc.titleApplication of Classical Lamination Theory to Fused Deposition Method 3-D Printed Plastics and Full Field Surface Strain Mappingen_US
dc.title.alternativeKlasik Laminasyon Teorisinin Üç Boyutlu Yazıcı ile Eriyik Yığma Modelleme Yöntemi Kullanılarak Üretilmiş Plastiklere Uygulanması ve Tam Alanlı Yüzey Gerinim Haritalanmasıen_US
dc.typearticleen_US
dc.contributor.departmentAGÜ, Mühendislik Fakültesi, Makine Mühendisliği Bölümüen_US
dc.contributor.authorID0000-0002-8063-151Xen_US
dc.contributor.authorID0000-0001-8288-2737en_US
dc.contributor.authorID0000-0003-1626-5858en_US
dc.contributor.institutionauthorYılmaz, Çağatay
dc.identifier.volume22en_US
dc.identifier.issue2en_US
dc.identifier.startpage342en_US
dc.identifier.endpage352en_US
dc.relation.journalAfyon Kocatepe Üniversitesi Fen ve Mühendislik Bilimleri Dergisien_US
dc.relation.publicationcategoryMakale - Ulusal Hakemli Dergi - Kurum Öğretim Elemanıen_US


Bu öğenin dosyaları:

Thumbnail

Bu öğe aşağıdaki koleksiyon(lar)da görünmektedir.

Basit öğe kaydını göster